Removal and installation of an amortizatorny rack of a back suspension bracket. Chery Amulet (since 2006 of release)
Chery Amulet since 2006
1. Car device
2. Recommendations about operation
3. Malfunctions in a way
4. Maintenance
5. Engine
6. Transmission
7. Running gear
7.1. Forward suspension bracket
7.2. Back suspension bracket
7.2.1. Features of a design
7.2.2. Possible malfunctions of a back suspension bracket, their reason and ways of elimination
7.2.3. Removal and installation of an amortizatorny rack of a back suspension bracket
7.2.4. Repair of an amortizatorny rack of a back suspension bracket
7.2.5. Replacement of the bearing of a back nave
7.2.6. Replacement of a beam of a back suspension bracket
8. Steering
9. Brake system
10. Electric equipment
11. Body
12. Appendices
13. Electric equipment schemes
 






8c4a8411



7-2-3-snyatie-i-ustanovka-amortizatornojj-stojjki-zadnejj-podveski.html

7.2.3. Removal and installation of an amortizatorny rack of a back suspension bracket

It be required to you: keys «on 7» (or welding pincers for keeping of a rod of the shock-absorber), «on 17» (two).

Preventions
Before lifting a back part of the car, include the I transfer and establish an emphasis under forward wheels. Having raised a back part, establish reliable support near a jack. Under a beam of a back suspension bracket to establish support it is impossible, as the suspension bracket should be unloaded.
Amortizatornye racks (left and right) replace with pairs.
Do not remove both amortizatorny are resistant at the same time on the hung-out back part of the car as lowering of a beam of a back suspension bracket below an admissible limit can lead to damage of pipelines and hoses of brake system.

1. Open a luggage carrier.
2. Remove a protective cap of the top support of an amortizatorny rack.
3. Unscrew the top nut of fastening of a rod of the shock-absorber, holding a rod from a provorachivaniye the second key.

Note
The rod of the shock-absorber can be held from a provorachivaniye and welding pincers.

4. Remove from a rod a washer.
5. Unscrew the bottom nut of fastening of a rod of the shock-absorber, holding a rod from a provorachivaniye the second key.
6. Remove from a rod the top pillow of fastening of a rack to a body.
7. Unscrew a nut of a bolt of the bottom fastening of an amortizatorny rack...
8.... also take a bolt from rack and arm eyes.
9. Take a shock-absorber eye from an arm...
10.... also remove an amortizatorny rack from the car.
11. Remove from a shock-absorber rod a persistent washer.
12. Establish an amortizatorny rack as it should be, the return to removal. Nuts of the top and bottom fastenings of a rack finally tighten on the car standing on the earth. Having lowered the car on the earth, several times strongly rock it. Tighten a nut of a bolt of the bottom fastening of a rack to a beam the moment of 70 N · m, nuts of the top fastening of a rack tighten till the moment a zazhatiya of rasporny plugs of pillows of its top fastening the moment of 15 N · m.

Prevention
At an inhaling of nuts of the top fastening of an amortizatorny rack do not make excessive effort, differently probably smyaty rasporny plugs.

«previous page
7.2.2. Possible malfunctions of a back suspension bracket, their reason and ways of elimination
following page»
7.2.4. Repair of an amortizatorny rack of a back suspension bracket