Chery Amulet since 2006
1. Car device
2. Recommendations about operation
3. Malfunctions in a way
3.1. The engine is not got
3.2. Malfunctions of system of injection of fuel
3.3. Idling was gone
3.4. Interruptions in operation of the engine
3.5. Diagnostics of a condition of the engine on appearance of spark plugs
3.6. The car moves breakthroughs
3.6.1. Breakthrough at the moment of a start of motion
3.6.2. Breakthroughs at dispersal
3.6.3. Breakthroughs at the established movement
3.7. The car is badly dispersed
3.8. The engine decayed during movement
3.9. Pressure of oil fell
3.10. Engine overheat
3.11. The storage battery is not recharged
3.12. Engine start-up from external sources of a current
3.13. Malfunctions of electric equipment
3.14. There were extraneous knocks
3.15. Problems with brakes
3.16. Wheel puncture
4. Maintenance
5. Engine
6. Transmission
7. Running gear
8. Steering
9. Brake system
10. Electric equipment
11. Body
12. Appendices
13. Electric equipment schemes



3.6.3. Breakthroughs at the established movement

Such breakthroughs happen are caused by malfunction of system of ignition more often. Diagnostics and repair (see section 10 "Electric equipment") are necessary. In a way it is possible to try to execute the independently following:
– attentively examine podkapotny space. Switch off ignition and check reliability of fastening and landing of all wires and sockets at the coil of ignition and high-voltage wires. Start up the engine and listen to its work: a crash at high-tension current breakdown on "weight" weak, but distinct. In full darkness it is well visible a spark at breakdown;
– replace spark plugs irrespective of their condition and run. Pay attention to a condition of candles: if it does not correspond to norm, probably, it is necessary to repair the engine or its systems.
Failure of the sensor of provision of the butterfly valve which has been built in throttle knot can be the specific reason of breakthroughs at the established movement of the Chery Amulet car.
The additional symptoms confirming malfunction of this sensor:
– non-uniform operation of the engine idling;
– decrease in the maximum engine capacity.
Cover of throttle knot not folding therefore it is not maintainable. If malfunction of the sensor (is revealed see. «Sensors of a control system with the engine»), replace throttle knot assembled with a cover.

«previous page
3.6.2. Breakthroughs at dispersal
following page»
3.7. The car is badly dispersed