Removal and installation of a steering wheel. Chery Amulet (since 2006 of release)
Chery Amulet since 2006
1. Car device
2. Recommendations about operation
3. Malfunctions in a way
4. Maintenance
5. Engine
6. Transmission
7. Running gear
8. Steering
8.1. Features of a design
8.2. Possible malfunctions of a steering with the hydraulic booster, their reasons and ways of elimination
8.3. Steering column
8.3.1. Removal and installation of a steering wheel
8.3.2. Removal and installation of a casing of a steering column
8.3.3. Removal and installation of a steering column
8.3.4. Replacement of a shaft of a steering and intermediate shaft
8.4. Steering drafts
8.5. Steering mechanism
9. Brake system
10. Electric equipment
11. Body
12. Appendices
13. Electric equipment schemes
 










8-3-1-snyatie-i-ustanovka-rulevogo-kolesa.html

8.3.1. Removal and installation of a steering wheel

You will need a face head «on 24».
1. Disconnect a wire from the minus plug of the storage battery.
2. Establish a steering wheel in the situation corresponding to rectilinear movement of the car.
3. Remove the module of a safety cushion of the driver (see. «Removal and installation of a safety cushion of the driver»).
4. For convenience of return installation mark the provision of a steering wheel concerning a shaft.
5. Weaken an inhaling of a nut of fastening of a steering wheel to a steering shaft, holding a steering wheel from a provorachivaniye.

Prevention
Nut of fastening of a wheel completely do not screw together from a shaft, differently at wheel removal by hands it is possible to put to itself a trauma in case of its sharp detachment from a shaft.

Good advice
To fix a steering wheel from a provorachivaniye it is possible by means of the locking mechanism of the anti-theft device of the lock of ignition. For this purpose take out a key from the lock of ignition and turn a steering wheel till shaft fixing by the anti-theft device. After weakening of an inhaling of a nut of fastening of a steering wheel disconnect the anti-theft device, having inserted a key into the ignition lock, and again establish a steering wheel in the situation corresponding to rectilinear movement.

6. In sharp blows of hands bring down a steering wheel from shliyets of a shaft...
7.... finally unscrew a nut of fastening of a steering wheel...
8.... also remove a steering wheel, having passed a plait of wires in an opening of its nave.
9. Establish a steering wheel and the removed details as it should be, the return to removal.

«previous page
8.3. Steering column
following page»
8.3.2. Removal and installation of a casing of a steering column