|
4-2-4-proverka-urovnya-i-dolivka-tormoznojj-zhidkosti-v-bachok.html
4.2.4. Check of level and a dolivka of brake liquid in a tank of a hydraulic actuator of brake systemIt be required to you: brake liquid, pure rag.
|
Good advice
Type of brake liquid — DOT-3, DOT-4.
At replacement of brake liquid in system remember or write down brand of liquid which will be filled in that at a dolivka to use the same brand.
|
The tank is established on the main brake cylinder on the left side of a motor compartment at a front board.
|
Prevention
Observe precautionary measures at work with brake liquid: it is toxic.
|
|
Good advice
In order that in the future not to subject itself to contingencies on repair of brake system, and even all car as a whole, in due time replace brake liquid fresh. It is very hygroscopic and absorbs moisture from air that, besides emergence of corrosion of details of brake system, lowers temperature of boiling of the liquid, and it can lead to refusal of brakes at frequent intensive braking.
Do not use the liquid merged from system repeatedly: it is polluted, saturated air and moisture.
Hit of brake liquid on wires, the plastic or painted details of a body can cause their damage therefore when filling always enclose pure rags. At liquid hit on these details at once wipe them a pure rag.
|
1. Check level of brake liquid in a tank. It should be between «MIN» and «MAX» labels put on case of a tank.
2. If level of liquid is lower than "MIN" label, unscrew a tank stopper...
|
Prevention
Gradual fall of level of brake liquid in the absence of leaks indicates, most likely, need of replacement of brake shoes. Check a condition of brake shoes (see. «Check of degree of wear of brake shoes, disks and drums»). Untimely replacement of blocks leads to expensive repair (replacement of brake disks, drums, supports)!
|
|
|
|
|
3.... also add brake liquid to «MAX» label.
|
4. Then wrap the tank stopper, the spilled liquid wipe a pure rag.
|
|
|
