Removal, defektovka and flywheel installation. Chery Amulet (since 2006 of release)
Chery Amulet since 2006
1. Car device
2. Recommendations about operation
3. Malfunctions in a way
4. Maintenance
5. Engine
5.1. Features of a design
5.2. Possible malfunctions of the engine, their reason and ways of elimination
5.3. Compression check in cylinders
5.4. Removal and installation of protection of a case of the engine
5.5. Replacement of support of a suspension bracket of the power unit
5.6. Installation of the piston of the first cylinder in the provision VMT of a step of compression
5.7. Removal, defektovka and flywheel installation
5.8. Replacement of details of consolidation of the engine
5.9. Head of the block of cylinders
5.10. Removal and engine installation
5.11. Engine repair
5.12. Greasing system
5.13. Cooling system
5.14. Power supply system
5.15. Catching system паров fuels
5.16. Cистема of production of the fulfilled gases
6. Transmission
7. Running gear
8. Steering
9. Brake system
10. Electric equipment
11. Body
12. Appendices
13. Electric equipment schemes
 










5-7-snyatie-defektovka-i-ustanovka-makhovika.html

5.7. Removal, defektovka and flywheel installation

Flywheel remove for replacement of details of coupling.
It be required to you: the tools necessary for removal of a transmission, and also a dvenadtsatigranny face key «on 9».
1. Remove a transmission (see. «Removal and transmission installation»).
2. Turn out nine bolts of fastening of a flywheel to a leading disk of coupling...
3.... also remove a flywheel together with a conducted disk of coupling.
4. Check a condition of teeths of a rim of a flywheel and in case of damage replace a flywheel.
5. Replace or repair a flywheel if on surfaces of a prileganiye of a conducted disk of coupling there are risks or teases.
To check and repair a flywheel it is possible in a workshop having the special equipment.
Not planeness of surfaces of a prileganiye of a conducted disk of coupling should not exceed 0,05 mm.
Palpation of a flywheel should not exceed 0,15 mm.
6. Establish a flywheel as it should be, the return to removal, having combined a pin on a flywheel with a special cut on a leading disk of coupling.

«previous page
5.6. Installation of the piston of the first cylinder in the provision VMT of a step of compression
following page»
5.8. Replacement of details of consolidation of the engine