9.10.1. Adjustment of a drive of the parking brake

For preliminary check of correctness of adjustment of a drive of the parking brake lift the drive lever up against the stop, thus you should hear 3–5 clicks of the ratchet device. If the number of clicks does not keep within the specified interval or the car is not kept by the parking brake (see. «Check of the parking brake»), adjust a drive.

The adjusting knot of a drive of the parking brake is located in salon under facing of a tunnel of a floor.

It be required to you: two keys «on 10», пассатижи.

1. Check correctness of adjustment of gaps between brake shoes and drums of brake mechanisms of back wheels. For this purpose several times strongly press a brake pedal at the lever of a drive of the parking brake lowered against the stop down.

2. Will hang out a back part of the car and establish it on reliable support.

3. Remove a back part of facing of a tunnel of a floor (see. «Removal and installation of facing of a tunnel of a floor»).

Note The seat of the driver is removed for descriptive reasons. To get access to fastenings of facing and to adjusting knot of a drive of the parking brake, to remove a seat it is not required.

4. Lift the lever of the parking brake on four clicks.	5. Weaken an inhaling of lock-nuts...

6.... and, holding cables from a provorachivaniye, in turn wrap adjusting nuts till a full zatormazhivaniye of back wheels.

7. Tighten lock-nuts and establish a back part of facing of a tunnel of a floor.

8. Establish the car on wheels.