Removal and installation of the lever of a drive of the parking brake. Chery Amulet (since 2006 of release)
Chery Amulet since 2006
1. Car device
2. Recommendations about operation
3. Malfunctions in a way
4. Maintenance
5. Engine
6. Transmission
7. Running gear
8. Steering
9. Brake system
9.1. Features of a design
9.2. Possible malfunctions of brake system, their reason and ways of elimination
9.3. Pumping of a hydraulic actuator of brake system
9.4. Check and adjustment of a pedal of a brake
9.5. Main brake cylinder
9.6. Vacuum amplifier of brakes
9.7. Replacement of hoses and tubes of a hydraulic actuator of brakes
9.8. Brake mechanisms of forward wheels
9.9. Brake mechanisms of back wheels
9.10. Parking brake
9.10.1. Adjustment of a drive of the parking brake
9.10.2. Replacement of cables of a drive of the parking brake
9.10.3. Removal and installation of the lever of a drive of the parking brake
9.11. Anti-blocking system of brakes
10. Electric equipment
11. Body
12. Appendices
13. Electric equipment schemes
 






8c4a8411



9-10-3-snyatie-i-ustanovka-rychaga-privoda-stoyanochnogo-tormoza.html

9.10.3. Removal and installation of the lever of a drive of the parking brake

The lever of a drive of the parking brake remove for replacement at wear or damage of gear sector or a doggie.
It be required to you: a face head «on 13», two keys «on 10», пассатижи, a screw-driver with a flat edge.
1. Disconnect a wire from the minus plug of the storage battery.
2. Remove a back part of facing of a tunnel of a floor (see. «Removal and installation of facing of a tunnel of a floor»).
3. Weaken an inhaling of lock-nuts...
4.... and, holding cables from a provorachivaniye, unscrew adjusting nuts.
5. Disconnect a block of a plait of wires from a conclusion of the switch of an alarm lamp of turning on of the parking brake.
6. Unscrew two nuts of fastening...
7.... also remove the lever of a drive of the parking brake.
8. Before installation of the lever of a drive on the car grease with konsistentny greasing its gear sector.
9. Establish the lever as it should be, the return to removal, and adjust lay brake system (see. «Adjustment of a drive of the parking brake»).

«previous page
9.10.2. Replacement of cables of a drive of the parking brake
following page»
9.11. Anti-blocking system of brakes