Removal and installation of a forward wing. Chery Amulet (since 2006 of release)
Chery Amulet since 2006
1. Car device
2. Recommendations about operation
3. Malfunctions in a way
4. Maintenance
5. Engine
6. Transmission
7. Running gear
8. Steering
9. Brake system
10. Electric equipment
11. Body
11.1. Features of a design
11.2. Possible malfunctions of a body, their reason and ways of elimination
11.3. Removal and installation of facing of a radiator
11.4. Removal, dismantling and installation of bumpers
11.5. Removal and installation of mudguards of wheels and podkrylok
11.6. Removal and installation of a forward wing
11.7. Removal and installation of a lattice and facing of a box of airinflow
11.8. Cowl
11.9. Lateral doors
11.10. Back door
11.11. Removal and installation of a cover of the hatch of a bulk pipe of a fuel tank
11.12. Seats
11.13. Removal and installation of facing of a tunnel of a floor
11.14. System of passive safety (SRS)
11.15. Removal and installation of external rear-view mirrors
11.16. Removal and installation of casings of a steering column
11.17. Dashboard
11.18. Heater and conditioner
11.19. Salon fittings
11.20. Screen wiper of a wind window
11.21. Replacement of a motionless glazing of a body
11.22. Care of a body
12. Appendices
13. Electric equipment schemes
 










11-6-snyatie-i-ustanovka-perednego-kryla.html

11.6. Removal and installation of a forward wing

You will need a key «on 10».

Note
Removal and installation are shown on an example of the left wing, the right wing remove similarly.

2. Turn out two bolts of fastening of a forward wing to a forward rack of a body...
3.... one bolt of fastening to a body of the back lower part of a wing...
4.... two bolts of fastening of a forward part of a wing...
5.... six bolts of the top fastening of a wing to a framework of a motor compartment also remove a wing.
6. Establish a forward wing and all earlier removed details upside-down.

«previous page
11.5. Removal and installation of mudguards of wheels and podkrylok
following page»
11.7. Removal and installation of a lattice and facing of a box of airinflow