Removal and installation of external rear-view mirrors. Chery Amulet (since 2006 of release)
Chery Amulet since 2006
1. Car device
2. Recommendations about operation
3. Malfunctions in a way
4. Maintenance
5. Engine
6. Transmission
7. Running gear
8. Steering
9. Brake system
10. Electric equipment
11. Body
11.1. Features of a design
11.2. Possible malfunctions of a body, their reason and ways of elimination
11.3. Removal and installation of facing of a radiator
11.4. Removal, dismantling and installation of bumpers
11.5. Removal and installation of mudguards of wheels and podkrylok
11.6. Removal and installation of a forward wing
11.7. Removal and installation of a lattice and facing of a box of airinflow
11.8. Cowl
11.9. Lateral doors
11.10. Back door
11.11. Removal and installation of a cover of the hatch of a bulk pipe of a fuel tank
11.12. Seats
11.13. Removal and installation of facing of a tunnel of a floor
11.14. System of passive safety (SRS)
11.15. Removal and installation of external rear-view mirrors
11.16. Removal and installation of casings of a steering column
11.17. Dashboard
11.18. Heater and conditioner
11.19. Salon fittings
11.20. Screen wiper of a wind window
11.21. Replacement of a motionless glazing of a body
11.22. Care of a body
12. Appendices
13. Electric equipment schemes
 






8c4a8411



11-15-snyatie-i-ustanovka-naruzhnykh-zerkal-zadnego-vida.html

11.15. Removal and installation of external rear-view mirrors

You will need a screw-driver with a crosswise edge.

Note
This operation is shown on an example of the left external mirror, the right external mirror remove and establish similarly.

1. Disconnect a wire from the minus plug of the storage battery.
2. Remove an upholstery of a forward door and a vlagozashchitny film (see. «Removal and installation of an upholstery of a forward door»).
3. Compress a clamp...
4.... also separate a block of a plait of wires of the left external mirror.
5. Turn out two screws of fastening...
6.... also remove a decorative slip, deducing a clamp of the top fastening of a slip from an opening.
7. Turn out three screws of fastening of the left external mirror...
8.... also remove it, deducing a plait of wires of a mirror from an opening at doors.
9. Turn out three screws of fastening...
10.... also remove a mirror arm.
11. Establish details as it should be, the return to removal.

«previous page
11.14.6. Removal and installation of the electronic control unit by additional system of passive safety
following page»
11.16. Removal and installation of casings of a steering column