Chery Amulet since 2006
	1. Car device
	2. Recommendations about operation
	3. Malfunctions in a way
	4. Maintenance
	5. Engine
	6. Transmission
	7. Running gear
	8. Steering
	9. Brake system
	10. Electric equipment
	11. Body
		11.1. Features of a design
		11.2. Possible malfunctions of a body, their reason and ways of elimination
		11.3. Removal and installation of facing of a radiator
		11.4. Removal, dismantling and installation of bumpers
		11.5. Removal and installation of mudguards of wheels and podkrylok
		11.6. Removal and installation of a forward wing
		11.7. Removal and installation of a lattice and facing of a box of airinflow
		11.8. Cowl
		11.9. Lateral doors
		11.10. Back door
		11.11. Removal and installation of a cover of the hatch of a bulk pipe of a fuel tank
		11.12. Seats
		11.13. Removal and installation of facing of a tunnel of a floor
		11.14. System of passive safety (SRS)
			11.14.1. Features of a design
			11.14.2. Removal and installation of a safety cushion of the driver
			11.14.3. Removal and installation of a safety cushion of the forward passenger
			11.14.4. Replacement of a forward seat belt
			11.14.5. Replacement of a back seat belt
			11.14.6. Removal and installation of the electronic control unit by additional system of passive safety
		11.15. Removal and installation of external rear-view mirrors
		11.16. Removal and installation of casings of a steering column
		11.17. Dashboard
		11.18. Heater and conditioner
		11.19. Salon fittings
		11.20. Screen wiper of a wind window
		11.21. Replacement of a motionless glazing of a body
		11.22. Care of a body
	12. Appendices
	13. Electric equipment schemes

C1111-8PLTEEA по материалам http://server-world.ru.

11-14-6-snyatie-i-ustanovka-ehlektronnogo-bloka-upravleniya-dopolnitelnojj-sistemojj-passivnojj-bezopasnosti.html

11.14.6. Removal and installation of the electronic control unit by additional system of passive safety

It be required to you: TORX T30 key, a screw-driver with a crosswise edge.

1. Disconnect a wire from the minus plug of the storage battery.

2. Remove facing of a tunnel of a floor (see. «Removal and installation of facing of a tunnel of a floor»).

3. Remove the dashboard (see. «Removal, dismantling and dashboard installation»).


4. Turn out two screws of fastening of the distributor of supply of air on the left side...	5.... one screw of fastening on the right side...


6.... also remove the distributor of supply of air.	7. Cast away a clamp of a block of a plait of wires of the electronic control unit...


8.... also disconnect a block from a block conclusion.	9. Turn out one screw of fastening of the block on the left side...

10.... two screws on the right side also remove the control unit.

Note

Pay attention to control unit marking, for replacement get the block with the same marking. The control unit can be established on the car only in one situation: the arrow on the case of the block should be directed forward in the direction of movement of the car.

11. Establish the electronic control unit system of passive safety and all removed details upside-down.

«previous page
11.14.5. Replacement of a back seat belt

following page»
11.15. Removal and installation of external rear-view mirrors