Chery Amulet since 2006
1. Car device
2. Recommendations about operation
3. Malfunctions in a way
4. Maintenance
5. Engine
6. Transmission
7. Running gear
8. Steering
9. Brake system
10. Electric equipment
11. Body
11.1. Features of a design
11.2. Possible malfunctions of a body, their reason and ways of elimination
11.3. Removal and installation of facing of a radiator
11.4. Removal, dismantling and installation of bumpers
11.5. Removal and installation of mudguards of wheels and podkrylok
11.6. Removal and installation of a forward wing
11.7. Removal and installation of a lattice and facing of a box of airinflow
11.8. Cowl
11.9. Lateral doors
11.10. Back door
11.11. Removal and installation of a cover of the hatch of a bulk pipe of a fuel tank
11.12. Seats
11.13. Removal and installation of facing of a tunnel of a floor
11.14. System of passive safety (SRS)
11.14.1. Features of a design
11.14.2. Removal and installation of a safety cushion of the driver
11.14.3. Removal and installation of a safety cushion of the forward passenger
11.14.4. Replacement of a forward seat belt
11.14.5. Replacement of a back seat belt
11.14.6. Removal and installation of the electronic control unit by additional system of passive safety
11.15. Removal and installation of external rear-view mirrors
11.16. Removal and installation of casings of a steering column
11.17. Dashboard
11.18. Heater and conditioner
11.19. Salon fittings
11.20. Screen wiper of a wind window
11.21. Replacement of a motionless glazing of a body
11.22. Care of a body
12. Appendices
13. Electric equipment schemes
 






8c4a8411




11-14-4-zamena-perednego-remnya-bezopasnosti.html

11.14.4. Replacement of a forward seat belt

It be required to you: a key or a face head «on 17», a screw-driver with a flat edge.

Note
Replacement of forward seat belts is shown on an example of a seat belt of the driver. A seat belt of the forward passenger replace similarly.

1. Disconnect a wire from the minus plug of the storage battery.

Preventions
After a wire detachment from the minus plug of the storage battery it is necessary to wait for not less than 10 mines and only after that it is possible to start removal of the seat belt equipped with a prednatyazhitel.
Dismantling of prednatyazhitel of belts is forbidden.
Falling of coils of belts with prednatyazhitel and hit in them of water and oil is not allowed.
Influence on prednatyazhitel of belts of temperature above 95 °C is not allowed.

2. Remove the lower part of facing of the central rack (see. «Removal and installation of facings of salon»).

Note
The seat of the driver is for descriptive reasons removed.

3. Turn out two screws of fastening directing a belt to the central rack.
4. Remove a decorative cap from the bottom bolt of fastening of a belt...
5.... also turn out a bolt.

Prevention
On bolts of fastening of a belt remote plugs are established, do not lose them at belt replacement.

6. Remove a decorative overlay of a buckle...
7.... also turn out a bolt of the top fastening of a belt.
8. Turn out a bolt of fastening of the inertial coil...
9.... also take the coil from a body rack.
10. Turn out a bolt of fastening of knot for adjustment of provision of a belt on height...
11.... shift adjusting knot up...
12.... also remove it, having deduced clamps from rack grooves.
13. For removal of the lock of a forward seat belt turn out a bolt of fastening of the lock from the left back side of a driver's seat and remove the lock.
14. Establish details as it should be, the return to removal.

«previous page
11.14.3. Removal and installation of a safety cushion of the forward passenger
following page»
11.14.5. Replacement of a back seat belt