|
5-15-2-snyatie-ustanovka-i-proverka-klapana-produvki-adsorbera.html
5.15.2. Removal, installation and check of the valve of a purge of an adsorberIt be required to you: rubber pear, source of a direct current tension of 12 Century.
1. Disconnect a wire from the minus plug of the storage battery.
2. Press a spring clamp of a block of a motor plait of wires and disconnect a block from the valve.
|
Note
For descriptive reasons the throttle knot is removed.
|
3. Remove from an arm of the inlet pipeline and disconnect from its unions bringing and taking-away hoses.
|
Note
So the electromagnetic valve of a purge of an adsorber removed from the car looks. Pay attention to its marking that at replacement to establish the same valve.
|
|
|
|
|
4. For check of the valve attach to the bringing union of the valve a pear (it use as the pump, and the hose of a supply of depression to the valve can use as an adapter for pear accession). Press on a pear — in the valve pressure should be created.
|
5. Then connect to valve conclusions a source of a direct current tension 12 In — the valve should open, and pressure should disappear (a pear will be compressed without resistance). Otherwise replace the valve.
|
6. Establish the valve of a purge of an adsorber as it should be, the return to removal.
| 