Removal and adsorber installation. Chery Amulet (since 2006 of release)
Chery Amulet since 2006
1. Car device
2. Recommendations about operation
3. Malfunctions in a way
4. Maintenance
5. Engine
5.1. Features of a design
5.2. Possible malfunctions of the engine, their reason and ways of elimination
5.3. Compression check in cylinders
5.4. Removal and installation of protection of a case of the engine
5.5. Replacement of support of a suspension bracket of the power unit
5.6. Installation of the piston of the first cylinder in the provision VMT of a step of compression
5.7. Removal, defektovka and flywheel installation
5.8. Replacement of details of consolidation of the engine
5.9. Head of the block of cylinders
5.10. Removal and engine installation
5.11. Engine repair
5.12. Greasing system
5.13. Cooling system
5.14. Power supply system
5.15. Catching system паров fuels
5.15.1. Features of the device
5.15.2. Removal, installation and check of the valve of a purge of an adsorber
5.15.3. Removal and adsorber installation
5.16. Cистема of production of the fulfilled gases
6. Transmission
7. Running gear
8. Steering
9. Brake system
10. Electric equipment
11. Body
12. Appendices
13. Electric equipment schemes
 






8c4a8411



5-15-3-snyatie-i-ustanovka-adsorbera.html

5.15.3. Removal and adsorber installation

паров fuels remove an adsorber of system of catching for check or replacement at emergence of persistent smell of the gasoline caused by its leakage. Besides, violation of tightness of an adsorber can become the reason of unstable operation of the engine idling up to its stop.
The adsorber is established in a niche of the right forward wheel.
It be required to you: a key «on 10», a screw-driver with a crosswise edge, бокорезы.
1. Remove the air filter (see. «Removal and installation of the air filter»).
2. Remove a podkrylok of the right forward wheel (see. «Removal and installation of mudguards of wheels and podkrylok»).
3. Have a bite collars of fastening of hoses to adsorber unions...
4.... also disconnect the taking away...
5.... and bringing hoses from adsorber unions.
6. Turn out two bolts of fastening of an arm of an adsorber to an engine mudguard.
7. Turn out the coupling screw of an arm of an adsorber.
8. Unclench an adsorber arm so that triangular ledges of an adsorber left rectangular openings of an arm...
9.... also remove an adsorber from the car.
10. Establish an adsorber as it should be, the return to removal.

Note
At connection of hoses to unions of an adsorber be guided on the shooters put at the basis of unions and specifying the direction of movement паров of fuel. Besides, diameter of the taking-away union more than diameter of the bringing.

«previous page
5.15.2. Removal, installation and check of the valve of a purge of an adsorber
following page»
5.16. Cистема of production of the fulfilled gases