Chery Amulet since 2006
1. Car device
2. Recommendations about operation
3. Malfunctions in a way
4. Maintenance
5. Engine
6. Transmission
7. Running gear
7.1. Forward suspension bracket
7.1.1. Features of a design
7.1.2. Possible malfunctions of a forward suspension bracket, their reason and ways of elimination
7.1.3. Removal and installation of an amortizatorny rack of a forward suspension bracket
7.1.4. Repair of an amortizatorny rack of a forward suspension bracket
7.1.5. Replacement of the top support of an amortizatorny rack
7.1.6. Replacement of a spherical support
7.1.7. Removal and installation of a cross-piece of a forward suspension bracket
7.1.8. Replacement of the lever of a forward suspension bracket
7.1.9. Replacement of details of the stabilizer of cross-section stability of a forward suspension bracket
7.1.10. Removal and installation of a rotary fist
7.1.11. Replacement of the bearing of a forward nave
7.2. Back suspension bracket
8. Steering
9. Brake system
10. Electric equipment
11. Body
12. Appendices
13. Electric equipment schemes
 






8c4a8411




7-1-11-zamena-podshipnika-perednejj-stupicy.html

7.1.11. Replacement of the bearing of a forward nave

In a nave the ball dvukhryadny bearing which during operation does not demand adjustment and greasing is established. At a nave vypressovka the bearing collapses, therefore выпрессовывайте a nave from a rotary fist only for replacement.
It be required to you: a key «on 13», a stripper of lock rings, a stripper of bearings, a screw-driver with a crosswise edge.

Note
We recommend to replace bearings of both naves of forward wheels at the same time.

1. Remove a rotary fist (see. «Removal and installation of a rotary fist»).
2. Turn out the screw of fastening of a brake disk to a nave...
3.... also remove a disk.
4. Turn out two bolts of fastening to a fist of an antisplash guard...
5.... also remove a guard.
6. Compress a stripper a lock ring of the bearing...
7.... also take it from a fist pro-point.
8. Vypressuyte a nave, using an opravka of suitable diameter (for example, a face head from a tool kit).

Preventions
Most likely, on a nave there will be an external half of an internal ring of the bearing. Remove it from a nave a stripper.
After nave removal the bearing is not suitable for a reuse, therefore it is necessary to replace it.

9. Overturn a nave other party up and выпрессуйте from a fist the bearing, using an opravka of suitable diameter.

Note
The bearing can be beaten out from a fist a hammer as the vypressovanny bearing is not subject to a reuse.

10. Clear details and grease an internal surface of a nest of a fist and an external surface of a nave with a thin layer of Litol-24 greasing.
11. Press the new bearing against the stop in a nest fillet in a fist.
12. Establish a lock ring of the bearing in a fist pro-point.
13. Press a nave in the bearing against the stop, having propped up a support an internal ring of the bearing.

Prevention
If at a press fitting of a nave not to fix an internal ring of the bearing a support, it will be damaged.

14. Establish on a fist an antisplash guard, and on a nave — a brake disk.
15. Establish a rotary fist as it should be, the return to removal (see. «Removal and installation of a rotary fist»).

«previous page
7.1.10. Removal and installation of a rotary fist
following page»
7.2. Back suspension bracket