Chery Amulet since 2006
1. Car device
2. Recommendations about operation
3. Malfunctions in a way
4. Maintenance
5. Engine
6. Transmission
7. Running gear
7.1. Forward suspension bracket
7.1.1. Features of a design
7.1.2. Possible malfunctions of a forward suspension bracket, their reason and ways of elimination
7.1.3. Removal and installation of an amortizatorny rack of a forward suspension bracket
7.1.4. Repair of an amortizatorny rack of a forward suspension bracket
7.1.5. Replacement of the top support of an amortizatorny rack
7.1.6. Replacement of a spherical support
7.1.7. Removal and installation of a cross-piece of a forward suspension bracket
7.1.8. Replacement of the lever of a forward suspension bracket
7.1.9. Replacement of details of the stabilizer of cross-section stability of a forward suspension bracket
7.1.10. Removal and installation of a rotary fist
7.1.11. Replacement of the bearing of a forward nave
7.2. Back suspension bracket
8. Steering
9. Brake system
10. Electric equipment
11. Body
12. Appendices
13. Electric equipment schemes
 






8c4a8411




7-1-6-zamena-sharovojj-opory.html

7.1.6. Replacement of a spherical support

If check of a support confirmed need of its replacement (see. «Check of a technical condition of a forward suspension bracket on the car»), replace it.
It be required to you: keys «on 16», «on 17», «on 18», a key for bolts of wheels.
1. Lift and establish a forward part of the car on support. Remove a wheel.

Preventions
Brake the car the parking brake and establish under back wheels a protivootkatny emphasis ("boots").
Weaken and tighten bolts of fastening of a wheel only on the car standing on the earth.

2. Unscrew a nut of a bolt of klemmovy fastening of a finger of a spherical support in an eye of a rotary fist.
3. Turn out three bolts of fastening of a spherical support to the suspension bracket lever...
4.... also remove a mortgage plate of its fastening with privarny nuts.

Note
Strongly korrodirovanny or having damages of carving openings a plate replace.

5. Turn out the bottom bolt of fastening directing blocks of the forward brake mechanism to a rotary fist.

Note
The bolt of fastening directing blocks of the forward brake mechanism to a rotary fist is necessary for turning out because he does not allow to take out a bolt of klemmovy fastening of a finger of a spherical support in an eye of a rotary fist.

6. Take a bolt of klemmovy fastening of a finger of a spherical support from openings of an eye of a rotary fist...
7.... and, having taken a fist a little aside, remove a spherical support.
8. Establish a spherical support as it should be, the return to removal, without tightening finally a nut of a bolt of fastening of her finger in an eye of a rotary fist.

Prevention
At installation do not damage a protective cover of a spherical support.

9. Having lowered the car on the earth, several times strongly rock it. Tighten a nut of a bolt of fastening of a finger in an eye of a rotary fist.

Note
After replacement of a spherical support of a forward suspension bracket check and if necessary adjust corners of installation of wheels. Use services of the workshops having the special equipment.

«previous page
7.1.5. Replacement of the top support of an amortizatorny rack
following page»
7.1.7. Removal and installation of a cross-piece of a forward suspension bracket