Removal and installation of a rotary fist. Chery Amulet (since 2006 of release)
Chery Amulet since 2006
1. Car device
2. Recommendations about operation
3. Malfunctions in a way
4. Maintenance
5. Engine
6. Transmission
7. Running gear
7.1. Forward suspension bracket
7.1.1. Features of a design
7.1.2. Possible malfunctions of a forward suspension bracket, their reason and ways of elimination
7.1.3. Removal and installation of an amortizatorny rack of a forward suspension bracket
7.1.4. Repair of an amortizatorny rack of a forward suspension bracket
7.1.5. Replacement of the top support of an amortizatorny rack
7.1.6. Replacement of a spherical support
7.1.7. Removal and installation of a cross-piece of a forward suspension bracket
7.1.8. Replacement of the lever of a forward suspension bracket
7.1.9. Replacement of details of the stabilizer of cross-section stability of a forward suspension bracket
7.1.10. Removal and installation of a rotary fist
7.1.11. Replacement of the bearing of a forward nave
7.2. Back suspension bracket
8. Steering
9. Brake system
10. Electric equipment
11. Body
12. Appendices
13. Electric equipment schemes
 










7-1-10-snyatie-i-ustanovka-povorotnogo-kulaka.html

7.1.10. Removal and installation of a rotary fist

Rotary fist remove for its replacement in case of damage or for replacement of the bearing of a nave.
It be required to you: keys «on 17», «on 18», «on 19», a face head «on 30», a key-shestigrannik «on 5».
1. Lift and establish a forward part of the car on support. Remove a wheel.
2. Weaken an inhaling of a nut of a nave.

Note
The nut of a nave is tightened by the big moment. Before its otvorachivaniye fix a nave, having included the I transfer, and ask the assistant to press a pedal of a brake and to hold it till weakening of an inhaling of a nut.

3. Disconnect from the sensor of frequency of rotation of a wheel a block of a plait of wires, having compressed a clamp of its fastening.

Note
If remove a rotary fist for replacement...
... turn out a bolt of fastening of the sensor...
... also take it from a fist opening.

4. Vypressuyte from the lever of a rotary fist a finger of the hinge of an external tip of steering draft (see. «Replacement of an external tip of steering draft»).
5. Turn out two bolts of fastening directing blocks of a support of the brake mechanism to a rotary fist...
6.... remove a support from a fist, without disconnecting from it a hose...
7.... also tie up, for example, to a spring of a forward suspension bracket, without allowing a tension or hose excesses.
8. Disconnect from a lug of a rotary fist a finger of a spherical support of a forward suspension bracket (see. «Replacement of a spherical support»).
9. Finally unscrew a nave nut...
10.... also remove the washer established under it.
11. Separate a rotary fist and an amortizatorny rack (see. «Removal and installation of an amortizatorny rack»).
12. Remove a rotary fist assembled with a nave of a forward wheel and a brake disk, having pulled out from a nave a shaft of the external CV JOINT of a drive of a forward wheel.
13. Establish details as it should be, the return to removal.
14. Check and if necessary adjust corners of installation of wheels. Use services of the workshops having the special equipment.

«previous page
7.1.9. Replacement of details of the stabilizer of cross-section stability of a forward suspension bracket
following page»
7.1.11. Replacement of the bearing of a forward nave