Removal, installation and adjustment of the lock of a cowl and its drive. Chery Amulet (since 2006 of release)
Chery Amulet since 2006
1. Car device
2. Recommendations about operation
3. Malfunctions in a way
4. Maintenance
5. Engine
6. Transmission
7. Running gear
8. Steering
9. Brake system
10. Electric equipment
11. Body
11.1. Features of a design
11.2. Possible malfunctions of a body, their reason and ways of elimination
11.3. Removal and installation of facing of a radiator
11.4. Removal, dismantling and installation of bumpers
11.5. Removal and installation of mudguards of wheels and podkrylok
11.6. Removal and installation of a forward wing
11.7. Removal and installation of a lattice and facing of a box of airinflow
11.8. Cowl
11.8.1. Removal and cowl installation
11.8.2. Removal, installation and adjustment of the lock of a cowl and its drive
11.9. Lateral doors
11.10. Back door
11.11. Removal and installation of a cover of the hatch of a bulk pipe of a fuel tank
11.12. Seats
11.13. Removal and installation of facing of a tunnel of a floor
11.14. System of passive safety (SRS)
11.15. Removal and installation of external rear-view mirrors
11.16. Removal and installation of casings of a steering column
11.17. Dashboard
11.18. Heater and conditioner
11.19. Salon fittings
11.20. Screen wiper of a wind window
11.21. Replacement of a motionless glazing of a body
11.22. Care of a body
12. Appendices
13. Electric equipment schemes
 










11-8-2-snyatie-ustanovka-i-regulirovka-zamka-kapota-i-ego-privoda.html

11.8.2. Removal, installation and adjustment of the lock of a cowl and its drive

It be required to you: a key «on 10», a screw-driver with a crosswise edge, a drill, a drill in diameter of 5 mm, a zaklepochnik.

For removal of the lock of a cowl execute the following.
2. Drill four rivets of fastening of the lock of a cowl and take the lock from under the forward panel.
3. Disconnect a tip of a cable of a drive of the lock and remove the cowl lock.
4. Put the lock as it should be, the return to removal. Before installation of the lock of a cowl grease its details with konsistentny greasing, for example Litol.
5. If after installation the lock is indistinctly locked or hardly opens, adjust the provision of a latch (see below in this subsection).

For removal of a drive of the lock of a cowl execute the following.
1. Disconnect a drive cable from the cowl lock (see above in this subsection).
2. Turn out two screws of fastening of the handle of a drive to боковине bodies...
3.... also deduce the handle together with a cable from the dashboard.
4. Disconnect a tip of a cable of a drive of the lock of a cowl from the lever of the handle and remove it.
5. Take a cable, extending it in podkapotny space.
6. Establish details as it should be, the return to removal.

For removal of a latch of the lock of a cowl execute the following.
1. Turn out two bolts of fastening...
2.... also remove a latch of the lock of a cowl.
3. Establish a latch of the lock of a cowl as it should be, the return to removal.
4. If after installation the lock is indistinctly locked or hardly opens, adjust the provision of a latch.
5. Weaken an inhaling of bolts of fastening and, moving a latch in the cross-section or longitudinal direction, achieve an unaccented zakhlopyvaniye of a cowl. After that tighten screws of fastening of a latch.

«previous page
11.8.1. Removal and cowl installation
following page»
11.9. Lateral doors