Differential repair. Chery Amulet (since 2006 of release)
Chery Amulet since 2006
1. Car device
2. Recommendations about operation
3. Malfunctions in a way
4. Maintenance
5. Engine
6. Transmission
6.1. Coupling
6.2. Transmission
6.2.1. Features of a design
6.2.2. Possible malfunctions of a transmission, their reason and ways of elimination
6.2.3. Replacement of epiploons of a transmission
6.2.4. Removal and transmission installation
6.2.5. Dismantling and assembly of a transmission and defektovka of its details
6.2.6. Repair of a secondary shaft
6.2.7. Repair of primary shaft
6.2.8. Synchronizer repair
6.2.9. Differential repair
6.2.10. Repair of the mechanism of gear shifting
6.2.11. Repair of hinges of a drive of gear shifting
6.2.12. Removal, installation and repair of the coulisse of a control lever by a transmission
6.2.13. Adjustment of a drive of management by a transmission
6.3. Drives of forward wheels
7. Running gear
8. Steering
9. Brake system
10. Electric equipment
11. Body
12. Appendices
13. Electric equipment schemes
 






8c4a8411



6-2-9-remont-differenciala.html

6.2.9. Differential repair

Wear or breakage of details of differential can be one of the reasons of the increased noise in a transmission.
The conducted gear wheel of the main transfer of the Chery Amulet car is fixed on a differential box by rivets, and the axis of satellites of differential is fixed from axial shift by shaped heads of two diametrically located rivets. Because rivets separately in spare parts do not deliver and they расклепки need the powerful pressovy equipment, differential repair in garage conditions consists only in replacement of its bearings. At wear or damage of gear wheels of differential address on service for its repair or replacement assembled.

Note
At differential replacement assembled with a conducted gear wheel of the main transfer it is necessary to replace at the same time and a leading gear wheel (a secondary shaft) as these gear wheels select for noise and establish only in pair.

It be required to you: a universal stripper, an opravka for a press fitting of bearings, screw-drivers with a flat edge.
1. For replacement of the worn-out or damaged bearing press it from a pin of a box of differential.

Prevention
The bearing pressed in the shown way, for repeated installation is not suitable, as its separator is damaged. Therefore needlessly do not dismantle differential bearings.

2. Napressuyte differential bearings on pins of its box, putting effort to an internal ring.

Preventions
At a bearing napressovka with the annex of effort to a separator it will be damaged.
At replacement of bearings of differential surely replace their external rings established in cases of a transmission and coupling (see. «Dismantling and assembly of a transmission and defektovka of its details»).

Note
The worn-out or damaged basic ring of a semi-axial gear wheel replace.

«previous page
6.2.8. Synchronizer repair
following page»
6.2.10. Repair of the mechanism of gear shifting