Chery Amulet since 2006
1. Car device
2. Recommendations about operation
3. Malfunctions in a way
4. Maintenance
5. Engine
6. Transmission
6.1. Coupling
6.2. Transmission
6.2.1. Features of a design
6.2.2. Possible malfunctions of a transmission, their reason and ways of elimination
6.2.3. Replacement of epiploons of a transmission
6.2.4. Removal and transmission installation
6.2.5. Dismantling and assembly of a transmission and defektovka of its details
6.2.6. Repair of a secondary shaft
6.2.7. Repair of primary shaft
6.2.8. Synchronizer repair
6.2.9. Differential repair
6.2.10. Repair of the mechanism of gear shifting
6.2.11. Repair of hinges of a drive of gear shifting
6.2.12. Removal, installation and repair of the coulisse of a control lever by a transmission
6.2.13. Adjustment of a drive of management by a transmission
6.3. Drives of forward wheels
7. Running gear
8. Steering
9. Brake system
10. Electric equipment
11. Body
12. Appendices
13. Electric equipment schemes
 






8c4a8411 Замена разъема питания ноутбука видео.




6-2-3-zamena-salnikov-korobki-peredach.html

6.2.3. Replacement of epiploons of a transmission

It be required to you: a stripper of lock rings (or kruglogubets), a screw-driver with a flat edge, a hammer, an opravka.
1. For replacement of an epiploon of a semi-axis merge oil from a transmission (see. «Check of level and oil replacement in a transmission»).
2. Remove a wheel drive from a replaced epiploon (see. «Removal and installation of drives of forward wheels»).
3. Hook a cap in a semi-axis a screw-driver...
4.... also take it from a semi-axis nest.
5. Dissolve the ends of a lock ring...
6.... also remove from a shaft of a semi-axial gear wheel a ring...
7.... and remote washer.
8. Press a semi-axis from a shaft of a semi-axial gear wheel.


Prevention
The semi-axis is established on shlitsa of a shaft of a semi-axial gear wheel with a considerable tightness. At impossibility of its spressovka make-shifts use a universal stripper, differently it is possible to damage differential bearings.

9. Take an epiploon a screw-driver.
10. Grease a working edge of an epiploon with transmission greasing and press it an opravka of suitable diameter a working edge in a box.
11. An epiploon of primary shaft replace on the removed transmission. Take an epiploon a screw-driver.
12. Grease a working edge of an epiploon with transmission greasing and press it an opravka of suitable diameter a working edge in a box.
13. Establish details as it should be, the return to removal.

Note
For replacement of an epiploon of a rod of the mechanism of gear shifting it is necessary to remove and disassemble a gear shifting box (see. «Repair of the mechanism of gear shifting»).

«previous page
6.2.2. Possible malfunctions of a transmission, their reason and ways of elimination
following page»
6.2.4. Removal and transmission installation