Removal, installation and repair of the coulisse of a control lever by a transmission. Chery Amulet (since 2006 of release)
Chery Amulet since 2006
1. Car device
2. Recommendations about operation
3. Malfunctions in a way
4. Maintenance
5. Engine
6. Transmission
6.1. Coupling
6.2. Transmission
6.2.1. Features of a design
6.2.2. Possible malfunctions of a transmission, their reason and ways of elimination
6.2.3. Replacement of epiploons of a transmission
6.2.4. Removal and transmission installation
6.2.5. Dismantling and assembly of a transmission and defektovka of its details
6.2.6. Repair of a secondary shaft
6.2.7. Repair of primary shaft
6.2.8. Synchronizer repair
6.2.9. Differential repair
6.2.10. Repair of the mechanism of gear shifting
6.2.11. Repair of hinges of a drive of gear shifting
6.2.12. Removal, installation and repair of the coulisse of a control lever by a transmission
6.2.13. Adjustment of a drive of management by a transmission
6.3. Drives of forward wheels
7. Running gear
8. Steering
9. Brake system
10. Electric equipment
11. Body
12. Appendices
13. Electric equipment schemes
 






8c4a8411



6-2-12-snyatie-ustanovka-i-remont-kulisy-rychaga-upravleniya-korobkojj-peredach.html

6.2.12. Removal, installation and repair of the coulisse of a control lever by a transmission

Repair of the coulisse of a control lever by a transmission consists in control lever replacement at emergence of vibrations and increased люфта the lever, caused by wear of its spherical support. For lever replacement the coulisse is necessary for removing from the car.
It be required to you: the tools necessary for removal of system of production of fulfilled gases and thermoscreens, a key and a face head «on 13», a key-shestigrannik «on 4», a screw-driver with a flat edge.
1. Take out a cover frame from an opening in facing of a tunnel of a floor, overcoming resistance of its clamps...
2.... lift a cover on the lever...
3.... turn it inside out and, having dissolved cuts of the holder of a cover...
4.... disconnect the holder.
5. Screw together from the lever the handle...
6.... also remove the cover plug...
7.... cover...
8.... and holder.
9. Hook a screw-driver two clamps of facing of a tunnel of a floor...
10.... also remove them.
11. From below the car remove the additional exhaust silencer (see. «Replacement of the additional exhaust silencer»)...
12.... and converter of the fulfilled gases (see. «Replacement of converter of the fulfilled gases»).
13. Remove the forward thermoscreen (see. «Removal and installation of thermoscreens»).
14. Disconnect draft of management of a transmission from the coulisse of levers on a body (see. «Repair of hinges of a drive of gear shifting»).
15. Turn out four bolts of fastening of the coulisse to the body basis...
16.... and, having lowered down the coulisse through an aperture in the body basis, remove it from the car.
17. For control lever replacement with a transmission turn out a coupling bolt of a cracker of draft...
18.... also remove a cracker from the lever.
19. Unscrew two nuts of the holder of the hinge of the lever...
20.... having raised the lever, remove a podpyatnik...
21.... also take the lever together with a support and the holder from an opening of the case of the coulisse.
22. Establish the lever to the coulisse and the coulisse on the car, and also all removed details as it should be, the return to removal.

«previous page
6.2.11. Repair of hinges of a drive of gear shifting
following page»
6.2.13. Adjustment of a drive of management by a transmission