Chery Amulet since 2006
1. Car device
2. Recommendations about operation
3. Malfunctions in a way
4. Maintenance
5. Engine
6. Transmission
7. Running gear
8. Steering
9. Brake system
10. Electric equipment
10.1. Features of a design
10.2. Diagnostics of malfunctions of electric equipment
10.3. Assembly blocks
10.4. Storage battery
10.5. Generator
10.6. Starter
10.7. Switch (lock) of ignition
10.8. Electronic control system of the engine (ESUD)
10.9. Ignition system
10.10. Lighting, light and sound alarm system
10.11. Windscreen cleaner
10.12. Windscreen washer
10.13. Electrofans of system of cooling of the engine
10.14. Electric motor of the fan of system of heating (conditioning) and salon ventilation
10.15. Heating system of back glass
10.16. Removal and installation of the boss of the lighter
10.17. Combination of devices
10.18. Replacement of switches of the dashboard
10.19. Automobile audiosystem
10.20. Replacement of sensors and switches
10.20.1. Replacement of the sensor of an alarm lamp of emergency pressure drop of oil
10.20.2. Replacement of the switch of a backing
10.20.3. Replacement of the switch of a stoplight
10.20.4. Replacement of switches of a plafond of illumination of salon
10.20.5. Replacement of the switch of a plafond of illumination of a luggage carrier
10.20.6. Replacement of switches of a sound signal
11. Body
12. Appendices
13. Electric equipment schemes
 






8c4a8411




10-20-1-zamena-datchika-signalnojj-lampy-avarijjnogo-padeniya-davleniya-masla.html

10.20.1. Replacement of the sensor of an alarm lamp of emergency pressure drop of oil

The sensor of an alarm lamp of emergency pressure drop of oil will screw in the oil highway of the block of cylinders of the engine from its right side (on a photo the inlet pipeline is for descriptive reasons removed).
You will need a key «on 22».
1. Disconnect from the sensor the wire socket.
2. Weaken an inhaling of the sensor and, having turned out the sensor from the block of cylinders, remove it from the car.

Note
So the sensor of an alarm lamp of emergency pressure drop of oil removed from the car looks.

3. Execute express check of serviceability of the sensor. Connect to its conclusion and the case щупы a tester included in a mode of measurement of resistance. Remember value of resistance of the sensor.
4. Through an opening in the sensor union a metal core or a thick wire accurately press a sensor membrane. Resistance of the sensor should increase essentially. If it does not occur, the sensor is faulty.
5. Establish the sensor as it should be, the return to removal.

«previous page
10.20. Replacement of sensors and switches
following page»
10.20.2. Replacement of the switch of a backing