Chery Amulet since 2006
1. Car device
2. Recommendations about operation
3. Malfunctions in a way
4. Maintenance
5. Engine
6. Transmission
7. Running gear
8. Steering
9. Brake system
10. Electric equipment
11. Body
11.1. Features of a design
11.2. Possible malfunctions of a body, their reason and ways of elimination
11.3. Removal and installation of facing of a radiator
11.4. Removal, dismantling and installation of bumpers
11.5. Removal and installation of mudguards of wheels and podkrylok
11.6. Removal and installation of a forward wing
11.7. Removal and installation of a lattice and facing of a box of airinflow
11.8. Cowl
11.9. Lateral doors
11.10. Back door
11.11. Removal and installation of a cover of the hatch of a bulk pipe of a fuel tank
11.12. Seats
11.13. Removal and installation of facing of a tunnel of a floor
11.14. System of passive safety (SRS)
11.15. Removal and installation of external rear-view mirrors
11.16. Removal and installation of casings of a steering column
11.17. Dashboard
11.18. Heater and conditioner
11.19. Salon fittings
11.20. Screen wiper of a wind window
11.21. Replacement of a motionless glazing of a body
11.22. Care of a body
11.22.1. Wash of the car
11.22.2. Polishing of a paint and varnish covering
11.22.3. Anticorrosive protection of a body
11.22.4. Preparation and anticorrosive processing of the hidden cavities
11.22.5. Body sealing
11.22.6. Care of an upholstery and salon rugs
11.22.7. Wash of the engine
12. Appendices
13. Electric equipment schemes



11.22.2. Polishing of a paint and varnish covering

Good advice
Do not store the car under a prorezinenny cover and do not put on the painted surfaces of a body rubber subjects: they leave on a paint and varnish covering (especially light) dark stains which do not leave polishing.

For preservation of appearance of a body and the contents its long time in a good condition is necessary to polish a paint and varnish covering of a body periodically. Polishing means select according to a covering condition, strictly observe recommendations about their application.
The first 2–3 months of operation of the car wash a body covering with cold water. For polishing of a new covering (till 3 years) use bezabrazivny polishing means for new coverings.
At car operation from 3 to 5 years use autopolyroles for the weather-beaten coverings, containing a small amount of abrasive substances. In 5 years of intensive operation apply autopolyroles to old coverings.
In order to avoid drying полироля process a body a pure flannel manually small sites.
For elimination of minor defects of a paint and varnish covering it is possible to use polishing pastes PMA-1 or PMA-2. It is possible to polish manually and mechanically flannel or beaver-lamb circles.
Before the use mix paste, at a zagusteniye dilute it with water. After polishing wipe a surface a pure flannel.
Small chips and the scratches which have not broken a layer of earth, paint over a thin brush. If the layer of earth is broken, smooth out the damaged place a fine-grained emery paper, having removed corrosion traces. The smoothed-out place cover with a layer of earth (from a kraskoraspylitel, an aerosol ballonchik or a brush). When soil completely will dry, paint over enamel the damaged place.
If on a paint and varnish covering of the car bitumen got, at once remove it White-spiritom or an autocleaner of bitumen spots. Bitumen causes emergence of the yellow spots which are especially appreciable on a light paint and varnish covering.
Not less often than once in two years it is necessary to process means "Movil" the hidden cavities of a body and to put on a surface of wheel arches and the bottom anticorrosive mastic. We recommend to carry out these works at service station.

«previous page
11.22.1. Wash of the car
following page»
11.22.3. Anticorrosive protection of a body