Removal and installation of the switch (lock) of ignition. Chery Amulet (since 2006 of release)
Chery Amulet since 2006
1. Car device
2. Recommendations about operation
3. Malfunctions in a way
4. Maintenance
5. Engine
6. Transmission
7. Running gear
8. Steering
9. Brake system
10. Electric equipment
10.1. Features of a design
10.2. Diagnostics of malfunctions of electric equipment
10.3. Assembly blocks
10.4. Storage battery
10.5. Generator
10.6. Starter
10.7. Switch (lock) of ignition
10.7.1. Features of a design
10.7.2. Check of the switch (lock) of ignition
10.7.3. Removal and installation of the switch (lock) of ignition
10.8. Electronic control system of the engine (ESUD)
10.9. Ignition system
10.10. Lighting, light and sound alarm system
10.11. Windscreen cleaner
10.12. Windscreen washer
10.13. Electrofans of system of cooling of the engine
10.14. Electric motor of the fan of system of heating (conditioning) and salon ventilation
10.15. Heating system of back glass
10.16. Removal and installation of the boss of the lighter
10.17. Combination of devices
10.18. Replacement of switches of the dashboard
10.19. Automobile audiosystem
10.20. Replacement of sensors and switches
11. Body
12. Appendices
13. Electric equipment schemes
 










10-7-3-snyatie-i-ustanovka-vyklyuchatelya-zamka-zazhiganiya.html

10.7.3. Removal and installation of the switch (lock) of ignition

The switch (lock) of ignition established on a steering column, is fixed by a bolt and a lock ring. The switch (lock) of ignition can be changed, without removing a steering column.
It be required to you: a six-sided key «on 5», a stripper of lock rings.
1. Remove a steering wheel (see. «Removal and installation of a steering wheel»).
2. Remove casings of a steering column (see. «Removal and installation of casings of a steering column»).
3. Remove from a steering column a contact ring of switches of sound signals and podrulevy switches (see. «Replacement of podrulevy switches»).
4. Wring out a clamp and disconnect a block of a plait of wires from contact group of the lock of ignition.
5. Turn out a bolt of fastening of the lock of ignition to a steering column.
6. Unclench a lock ring of the lock of ignition...
7.... also remove a lock ring from a shaft of a steering column.
8. Remove from a shaft the plug...
9.... and spring...
10.... and then remove the ignition lock from a steering column.

Note
So the switch (lock) of ignition looks. Turn on its marking to get for replacement the same lock.

11. Establish details as it should be, the return to removal.

«previous page
10.7.2. Check of the switch (lock) of ignition
following page»
10.8. Electronic control system of the engine (ESUD)