Removal and control unit installation by heating and conditioning system. Chery Amulet (since 2006 of release)
Chery Amulet since 2006
1. Car device
2. Recommendations about operation
3. Malfunctions in a way
4. Maintenance
5. Engine
6. Transmission
7. Running gear
8. Steering
9. Brake system
10. Electric equipment
11. Body
11.1. Features of a design
11.2. Possible malfunctions of a body, their reason and ways of elimination
11.3. Removal and installation of facing of a radiator
11.4. Removal, dismantling and installation of bumpers
11.5. Removal and installation of mudguards of wheels and podkrylok
11.6. Removal and installation of a forward wing
11.7. Removal and installation of a lattice and facing of a box of airinflow
11.8. Cowl
11.9. Lateral doors
11.10. Back door
11.11. Removal and installation of a cover of the hatch of a bulk pipe of a fuel tank
11.12. Seats
11.13. Removal and installation of facing of a tunnel of a floor
11.14. System of passive safety (SRS)
11.15. Removal and installation of external rear-view mirrors
11.16. Removal and installation of casings of a steering column
11.17. Dashboard
11.18. Heater and conditioner
11.18.1. Features of the device
11.18.2. Removal and control unit installation by heating and conditioning system
11.19. Salon fittings
11.20. Screen wiper of a wind window
11.21. Replacement of a motionless glazing of a body
11.22. Care of a body
12. Appendices
13. Electric equipment schemes
 






8c4a8411



11-18-2-snyatie-i-ustanovka-bloka-upravleniya-sistemojj-otopleniya-i-kondicionirovaniya.html

11.18.2. Removal and control unit installation by heating and conditioning system

It be required to you: screw-drivers with flat and crosswise edges.
1. Disconnect a wire from the minus plug of the storage battery.
2. Remove an overlay of the central console (see. «Removal, dismantling and dashboard installation»).
3. Compress clamps...
4.... also disconnect a block of a plait of wires.
5. Similarly disconnect other blocks of plaits of wires from control unit conclusions a heater.
6. Having hooked for edge...
7.... remove the spring holder.
8. Disconnect a tip of a cable of a drive from a control lever heater zaslonka.
9. Similarly disconnect other cables of a drive a heater zaslonok from control unit levers...
10.... also remove the control unit heating and conditioning system.
11. Establish the control unit heating and conditioning system and all removed details as it should be, the return to removal.

«previous page
11.18.1. Features of the device
following page»
11.19. Salon fittings