Chery Amulet since 2006
1. Car device
2. Recommendations about operation
3. Malfunctions in a way
4. Maintenance
5. Engine
6. Transmission
7. Running gear
8. Steering
9. Brake system
10. Electric equipment
10.1. Features of a design
10.2. Diagnostics of malfunctions of electric equipment
10.3. Assembly blocks
10.4. Storage battery
10.4.1. Features of a design
10.4.2. Malfunctions of the storage battery, their reason and ways of elimination
10.4.3. Care of the storage battery
10.4.4. Check of level of electrolit in the storage battery
10.4.5. Check of degree of a zaryazhennost of the storage battery
10.4.6. Removal and installation of the storage battery
10.4.7. Charging of the storage battery
10.5. Generator
10.6. Starter
10.7. Switch (lock) of ignition
10.8. Electronic control system of the engine (ESUD)
10.9. Ignition system
10.10. Lighting, light and sound alarm system
10.11. Windscreen cleaner
10.12. Windscreen washer
10.13. Electrofans of system of cooling of the engine
10.14. Electric motor of the fan of system of heating (conditioning) and salon ventilation
10.15. Heating system of back glass
10.16. Removal and installation of the boss of the lighter
10.17. Combination of devices
10.18. Replacement of switches of the dashboard
10.19. Automobile audiosystem
10.20. Replacement of sensors and switches
11. Body
12. Appendices
13. Electric equipment schemes
 






8c4a8411




10-4-3-ukhod-za-akkumulyatornojj-batareejj.html

10.4.3. Care of the storage battery

Not less often than once in two weeks delete with dry rags a dust and dirt from a surface of a monoblock and a battery cover. If on a cover casually there was an electrolit, remove it with the pure rags moistened of 10 %-nym with solution of liquid ammonia or soda. Then dry wipe a cover surface.

Prevention
Clear a cover surface only at densely wrapped up jams in order to avoid electrolit pollution.

Watch that jams were always densely wrapped in mouths a banok. Not less often than once in two weeks check purity of openings for a gas make in jams as the contamination of these openings will cause increase of pressure of gas in the battery that can lead to its damage.
For prevention of oxidation of polar conclusions of the battery and tips of wires regularly clear them and grease with technical vaseline. Watch density of connection of tips of wires and conclusions.

Good advice
Instead of technical vaseline it is possible to apply medesoderzhashchy greasings available on sale to protection against oxidation of conclusions and tips.

Periodically check reliability of fastenings of the battery on the car and if necessary tighten them in order to avoid emergence of cracks on a monoblock.

Good advice
For reduction of the vibrations which are transferring to a monoblock of the battery, establish the battery on a rug from acidproof rubber.

Wires should be attached to conclusions of the battery with a weak point as the tension of wires can lead to shaking of conclusions in a cover and an electrolit leak.

«previous page
10.4.2. Malfunctions of the storage battery, their reason and ways of elimination
following page»
10.4.4. Check of level of electrolit in the storage battery