Chery Amulet since 2006
1. Car device
2. Recommendations about operation
3. Malfunctions in a way
4. Maintenance
5. Engine
6. Transmission
7. Running gear
8. Steering
9. Brake system
10. Electric equipment
10.1. Features of a design
10.2. Diagnostics of malfunctions of electric equipment
10.3. Assembly blocks
10.4. Storage battery
10.4.1. Features of a design
10.4.2. Malfunctions of the storage battery, their reason and ways of elimination
10.4.3. Care of the storage battery
10.4.4. Check of level of electrolit in the storage battery
10.4.5. Check of degree of a zaryazhennost of the storage battery
10.4.6. Removal and installation of the storage battery
10.4.7. Charging of the storage battery
10.5. Generator
10.6. Starter
10.7. Switch (lock) of ignition
10.8. Electronic control system of the engine (ESUD)
10.9. Ignition system
10.10. Lighting, light and sound alarm system
10.11. Windscreen cleaner
10.12. Windscreen washer
10.13. Electrofans of system of cooling of the engine
10.14. Electric motor of the fan of system of heating (conditioning) and salon ventilation
10.15. Heating system of back glass
10.16. Removal and installation of the boss of the lighter
10.17. Combination of devices
10.18. Replacement of switches of the dashboard
10.19. Automobile audiosystem
10.20. Replacement of sensors and switches
11. Body
12. Appendices
13. Electric equipment schemes
 






8c4a8411




10-4-4-proverka-urovnya-ehlektrolita-v-akkumulyatornojj-bataree.html

10.4.4. Check of level of electrolit in the storage battery

Periodically, not less often than once in two weeks check electrolit level in battery elements.

Note
At batteries with the general for all elements a cover equipped with a condenser cavity, it is allowed to check electrolit level once in two months.

Electrolit level should be in all elements between «MIN» and «MAX» labels put on translucent case of the storage battery. If labels are not present, level of electrolit should be higher than the top edge of separators on 5–10 mm.

Good advice
Electrolit level over the top edge of separators is convenient for checking a glass tubule, having lowered it in an element against the stop in a separator and having closed the free end of a tubule a finger.

For restoration of level of electrolit add only the distilled water. If it is precisely established that the reason of low level is the vypleskivaniye, add electrolit of the same density, as remained in a battery element. If level is higher than norm, pump out electrolit a rubber pear with an ebonitovy tip.

Prevention
To add in the storage battery the concentrated acid it is strictly forbidden!

«previous page
10.4.3. Care of the storage battery
following page»
10.4.5. Check of degree of a zaryazhennost of the storage battery