Chery Amulet since 2006
1. Car device
2. Recommendations about operation
3. Malfunctions in a way
4. Maintenance
5. Engine
5.1. Features of a design
5.2. Possible malfunctions of the engine, their reason and ways of elimination
5.3. Compression check in cylinders
5.4. Removal and installation of protection of a case of the engine
5.5. Replacement of support of a suspension bracket of the power unit
5.6. Installation of the piston of the first cylinder in the provision VMT of a step of compression
5.7. Removal, defektovka and flywheel installation
5.8. Replacement of details of consolidation of the engine
5.8.1. Replacement of laying of a cover of a head of the block of cylinders
5.8.2. Replacement of laying of a head of the block of cylinders
5.8.3. Replacement of maslosjemny caps
5.8.4. Replacement of an epiploon of a camshaft
5.8.5. Replacement of epiploons of a cranked shaft
5.8.6. Replacement of consolidation of an oil case
5.8.7. Replacement of laying of an inlet pipe
5.8.8. Replacement of laying of a final collector
5.9. Head of the block of cylinders
5.10. Removal and engine installation
5.11. Engine repair
5.12. Greasing system
5.13. Cooling system
5.14. Power supply system
5.15. Catching system ïàðîâ fuels
5.16. Cèñòåìà of production of the fulfilled gases
6. Transmission
7. Running gear
8. Steering
9. Brake system
10. Electric equipment
11. Body
12. Appendices
13. Electric equipment schemes
 






8c4a8411




5-8-1-zamena-prokladki-kryshki-golovki-bloka-cilindrov.html

5.8.1. Replacement of laying of a cover of a head of the block of cylinders

If an oil leak from under a cover of a head of the block of cylinders it was not possible to eliminate with a tightening of nuts of fastening of a cover, replace its laying.
It be required to you: a screw-driver, ïàññàòèæè, a key «on 10», a screw-driver with a crosswise edge.
1. Disconnect high-voltage wires from spark plugs, deduce wires from plastic holders on a cover of a head of the block of cylinders.
2. Unscrew three nuts of fastening of the holder of high-voltage wires...
3.... also remove the holder.
4. Weaken an inhaling of a collar of fastening of a taking-away hose of ventilation of karterny gases...
5.... also remove a hose from a branch pipe on a cover of a head of the block of cylinders.
6. Weaken a collar of fastening of a bringing hose of ventilation of karterny gases...
7.... also remove a hose from a branch pipe on a cover of a head of the block of cylinders.
8. Turn out six bolts and three hairpins of fastening of a cover of a head of the block of cylinders to a head of the block of cylinders...
9.... also uncover a head.
10. Remove laying from a cover of a head of the block of cylinders.
11. Establish new laying of a cover of a head of the block of cylinders and all earlier removed details upside-down. Tighten bolts and hairpins of fastening of a cover of a head of the block of cylinders in the sequence shown on a photo.

«previous page
5.8. Replacement of details of consolidation of the engine
following page»
5.8.2. Replacement of laying of a head of the block of cylinders