Removal and installation of the assembly block of salon. Chery Amulet (since 2006 of release)
Chery Amulet since 2006
1. Car device
2. Recommendations about operation
3. Malfunctions in a way
4. Maintenance
5. Engine
6. Transmission
7. Running gear
8. Steering
9. Brake system
10. Electric equipment
10.1. Features of a design
10.2. Diagnostics of malfunctions of electric equipment
10.3. Assembly blocks
10.3.1. Arrangement of safety locks and relay
10.3.2. Replacement of safety locks and the relay in assembly blocks
10.3.3. Removal and installation of the assembly block of salon
10.3.4. Removal and installation of the block of the relay and safety locks of headlights and conditioner
10.3.5. Removal and installation of the block of the relay and safety locks of electrofans of system of cooling
10.3.6. Removal and installation of the block of power safety locks
10.3.7. Replacement of additional safety locks and relay of system of injection of fuel
10.4. Storage battery
10.5. Generator
10.6. Starter
10.7. Switch (lock) of ignition
10.8. Electronic control system of the engine (ESUD)
10.9. Ignition system
10.10. Lighting, light and sound alarm system
10.11. Windscreen cleaner
10.12. Windscreen washer
10.13. Electrofans of system of cooling of the engine
10.14. Electric motor of the fan of system of heating (conditioning) and salon ventilation
10.15. Heating system of back glass
10.16. Removal and installation of the boss of the lighter
10.17. Combination of devices
10.18. Replacement of switches of the dashboard
10.19. Automobile audiosystem
10.20. Replacement of sensors and switches
11. Body
12. Appendices
13. Electric equipment schemes
 






8c4a8411



10-3-3-snyatie-i-ustanovka-montazhnogo-bloka-salona.html

10.3.3. Removal and installation of the assembly block of salon

The assembly block remove for replacement of conducting or at an oplavleniye of the plastic case of the block.
It be required to you: a key «on 10», screw-drivers with a crosswise and flat edge.
1. Disconnect a wire from the minus plug of the storage battery.
2. Remove the ware shelf located under a steering column (see. «Replacement of safety locks and the relay in assembly blocks»).
3. Deduce ledges of plastic holders of the assembly block from openings in a body arm...
4.... also remove holders.
5. Mark an arrangement of blocks of the relay and safety locks in order that it is correct to establish them on the case of the assembly block.
6. Wring out a screw-driver...
7.... also remove contact sockets of the relay and safety locks from the case of the assembly block.
8. Having wrung out clamps, disconnect blocks of plaits of wires from sockets of the assembly block...
9.... also remove the assembly block from the car.
10. Unscrew two nuts of fastening of the block of safety locks to the general case of the assembly block...
11.... also remove the block of safety locks.
12. Establish the assembly block as it should be, the return to removal.

«previous page
10.3.2. Replacement of safety locks and the relay in assembly blocks
following page»
10.3.4. Removal and installation of the block of the relay and safety locks of headlights and conditioner