Chery Amulet since 2006
	1. Car device
	2. Recommendations about operation
	3. Malfunctions in a way
	4. Maintenance
	5. Engine
	6. Transmission
	7. Running gear
	8. Steering
	9. Brake system
	10. Electric equipment
		10.1. Features of a design
		10.2. Diagnostics of malfunctions of electric equipment
		10.3. Assembly blocks
			10.3.1. Arrangement of safety locks and relay
			10.3.2. Replacement of safety locks and the relay in assembly blocks
			10.3.3. Removal and installation of the assembly block of salon
			10.3.4. Removal and installation of the block of the relay and safety locks of headlights and conditioner
			10.3.5. Removal and installation of the block of the relay and safety locks of electrofans of system of cooling
			10.3.6. Removal and installation of the block of power safety locks
			10.3.7. Replacement of additional safety locks and relay of system of injection of fuel
		10.4. Storage battery
		10.5. Generator
		10.6. Starter
		10.7. Switch (lock) of ignition
		10.8. Electronic control system of the engine (ESUD)
		10.9. Ignition system
		10.10. Lighting, light and sound alarm system
		10.11. Windscreen cleaner
		10.12. Windscreen washer
		10.13. Electrofans of system of cooling of the engine
		10.14. Electric motor of the fan of system of heating (conditioning) and salon ventilation
		10.15. Heating system of back glass
		10.16. Removal and installation of the boss of the lighter
		10.17. Combination of devices
		10.18. Replacement of switches of the dashboard
		10.19. Automobile audiosystem
		10.20. Replacement of sensors and switches
	11. Body
	12. Appendices
	13. Electric equipment schemes

10-3-6-snyatie-i-ustanovka-bloka-silovykh-predokhranitelejj.html

10.3.6. Removal and installation of the block of power safety locks

It be required to you: a key «on 10», a screw-driver with a crosswise edge.

1. Disconnect a wire from the minus plug of the storage battery.


2. Weaken an inhaling of a coupling bolt of a tip...	3.... also disconnect a wire from the plus plug of the storage battery.


4. Wring out clamps...	5.... also raise a cover of plugs of power wires.

6. Turn out screws of fastening of plugs of power wires to the block of power safety locks and remove the block.

7. Establish the block of power safety locks as it should be, the return to removal.

«previous page
10.3.5. Removal and installation of the block of the relay and safety locks of electrofans of system of cooling

following page»
10.3.7. Replacement of additional safety locks and relay of system of injection of fuel