4.3.4. Oil replacement in the engine and the oil filter

According to the manufacturer recommendation in the engine it is necessary to replace oil in one year of operation or 10 thousand km of run (that will come earlier).

Good advice Under trying conditions operation in the large city or strongly dusty district replace oil and the filter through each 5000 km.

It be required to you: engine oil, the oil filter, a pure rag, capacity (not less than 5 l) for merged oil, a key «on 13», a special key for an otvorachivaniye of the oil filter.

Good advice Oil merge after a trip while the engine did not cool down yet. If the engine cold, start up and warm up it to working temperature. Fill in oil of the same brand, as at oil which was in the engine. If all of you decided to replace oil brand, wash out greasing system flushing oil or oil of that brand which will be used. For this purpose after plum of old oil fill in new to the bottom label masloizmeritelny щупа. Start up the engine and let's to it work 10 mines idling. Merge oil and only after that replace the oil filter. Now can fill in new oil to demanded level (to the top label on щупе).

Prevention Do not merge the fulfilled oil on the earth.

1. Unscrew a stopper of a maslonalivny mouth.	2. Clear a metal brush, and then a rag a stopper of a drain opening of an oil case of the engine.

3. Unscrew a stopper of a drain opening, previously having substituted capacity for merged oil...	4.... also merge oil.

Prevention Be careful: oil is hotter!

Note On a stopper of a drain opening paronitovy laying is established. Strongly pressed out or damaged laying replace.

5. Wrap a stopper.	6. Shift the oil filter from a place a special key...

Note The oil filter is established on the right part of the block of cylinders of the engine around the 3rd cylinder.

7.... also remove the filter.

Good advice For an otvorachivaniye of the oil filter use a special key. If such key or a similar stripper is not present, punch the filter case a screw-driver and, using it as the lever, unscrew the filter. Punch the filter as it is possible closer to a bottom not to damage the union. It is possible to use and the strip of a rough emery paper curtailed twice, having wrapped up it the filter and having shifted it from a place hands.

8. If the sealing ring of the new filter is not processed by the manufacturer konsistentny greasing or talc, grease a ring with pure engine oil...	9.... also wrap the filter on a place (hands without use of the tool) on 3/4 turns from the moment of contact of a ring and a flange of the block of cylinders.

10. Fill in pure engine oil (see. «Check of level and an oil dolivka in system of greasing of the engine»).	11. Establish into place a stopper of a maslonalivny mouth.

12. Start up the engine and let's to it work idling some minutes (the alarm lamp of emergency pressure drop of oil should go out through 2–3 with the ambassador of start-up of the engine). In operating time of the engine check, whether is not present потеков some oil from under a stopper of a drain opening and the oil filter. Stop the engine, check oil level, if necessary add oil, tighten a stopper and the filter.