|
5-14-5-zamena-modulya-toplivnogo-nasosa.html
5.14.5. Replacement of the module of the fuel pumpIf engine capacity falls, periodic howlings or the increased noise at operation of the fuel pump, most likely, are audible the fuel pump failed.
At first check pressure in system of supply of fuel in the following order:
– if pressure in system in an idling mode less than 350 kPas (3,5 kgfs/cm2), remove the fuel module and wash out a grid of the filter of rough purification of fuel;
If in this case pressure does not increase, it is necessary to replace the fuel pump.
It be required to you: hammer, wooden drift.
2. Disconnect a wire from the minus plug of the storage battery.
|
|
|
|
3. Open a door of a back and remove a luggage carrier rug.
|
4. Turn out three screws of fastening of a cover of the hatch of the fuel module...
|
|
|
|
|
5.... also uncover.
|
6. Wring out a clamp...
|
|
|
|
|
7.... also disconnect a block of a plait of wires from the module of the fuel pump.
|
8. Press a clamp and disconnect from the union of the module of the fuel pump a tip топливопровода a high pressure.
|
|
|
|
|
9. Similarly disconnect a tip drain топливопровода.
|
10. Weaken an inhaling of a nut of fastening of the module of the fuel pump, striking easy blows with a hammer through a wooden pro-rate to nut ledges.
|
|
|
|
|
11. Turn on and remove a nut.
|
12. Take from a tank the module, having inclined it sideways not to bend the lever of the sensor of the index of level of fuel and not to turn a float on the lever. Otherwise index indications in a combination of devices will be incorrect. Merge from a glass of the fuel module fuel in in advance prepared capacity.
|
13. Remove a rubber sealing ring of the fuel pump. Strongly pressed out, hardened or torn ring surely replace in order to avoid a gasoline leak.
14. Establish the fuel module and all removed details as it should be, the return to removal.
|
Note
At connection топливопроводов be guided by arrows on the unions, supply of fuel indicating the direction.
|
| 